Bosch · Olympia · Dishwashers · Induction & gas ranges · E-codes
Bosch appliance repair in Olympia, E15 to E24 and beyond
A Bosch dishwasher runs so quietly that trouble usually announces itself as an E-number on the door and a puddle on the floor.
- BOSCH Bosch E15 water in base
- ON PAPER one written figure after testing; say yes and the visit fee is already inside it
- SAME-DAY often open for a refrigerator losing cold · Open 8–7, Mon to Sat
Open 8–7, Mon to Sat · Sundays off · same-day visits often open, the shop confirms by phone · Woodland Square Loop, at the Olympia–Lacey line
Book a visit
Pick a day for the van
Three short steps: the machine, a day and an arrival window, then the address. The shop rings back to confirm, and the visit fee is quoted on that call.
- Pick the day and the window that suit you
- A call from the shop to confirm, no texts
- One written figure after testing, nothing started without your yes
- Visit fee folded into any repair you approve
Bosch machines we take
Every machine, every model year
E15 and E24 are the Bosch dishwasher codes we hear most: E15 halts the cycle because water has reached the base pan, and E24 means the machine hums but cannot drain. Cold, dripping plates point to the heating side instead. We find which likely cause fits your kitchen before replacing anything, and we repair Bosch ranges too. Online booking holds a date and arrival window for you, with a confirming call from dispatch.
Bosch in Olympia kitchens
Bosch dishwashers arrived in Olympia with the kitchen remodel boom: the downtown condos on West Bay Drive, the reworked Craftsman kitchens in South Capitol, the custom builds up Cooper Point. Homeowners chose them for silence and for the stainless tub, and for years they got it. Then the machine starts stopping itself with E15, or hums without draining and shows E24, or finishes a cycle with cold, dripping plates. None of these are mysterious once the door panel is off, but all of them reward a technician who has seen the same fault sixty times and knows which of the three possible causes is the likely one in this particular kitchen.
We work out of the Woodland District, where Woodland Square Loop meets the Olympia–Lacey line, and we are an independent repair shop with no arrangement with Bosch. The diagnostic visit has a fee we state when you book, and what you receive for it is a technician testing the appliance with proper instruments, a clear statement of which component has failed, and a repair figure written out before the repair begins. Approve it and the visit fee is reckoned as a slice of that figure; pass on it and you owe nothing past the visit fee. Dishwashers and ranges are booked inside the week, and a Bosch refrigerator that has gone warm goes to the front of the day.
Bosch pages by machine
Bosch dishwasher repair
Water pooled in the bottom · film on the glasses · plates come out gritty · buttons unresponsive
OPEN →
Bosch range repair
One burner dead · oven never gets hot enough · endless clicking · F-code showing
OPEN →Bosch appliances and where they fail
| Bosch line | The call we get | Most frequent cause | Our fix |
|---|---|---|---|
| 300 / 500 / 800 dishwasher | E15 on the display, machine stops mid-cycle, pump runs constantly | The float has risen on water in the base pan; source is a sump seal, a hose, or a spray arm hitting a pot and splashing past the door | Dry the pan, chase the leak with the outer door removed, renew the seal or hose, re-level the machine |
| Any Bosch dishwasher | E24 or E25, water standing over the filter after the cycle ends | Filter choked with rice and jar labels, drain hose crimped where it passes the cabinet wall, or a check valve stuck; E25 leans toward the pump itself | Clean filter and sump, straighten the hose, test the drain pump impeller, replace the pump if it will not spin |
| Dishwasher with CrystalDry or condensation drying | Glasses come out wet, cycle seems short, E09 shown | Flow-through heater open, or the relay driving it burned on the control; on hard well water the heater is scaled over | Meter the heater, descale or replace it, replace the control if the relay is what failed |
| Gas range or rangetop | One burner clicks forever, or all burners spark when one is turned | Spark module shorted through a damp or cracked electrode, frequently after a boilover | Dry and clean electrodes, replace the cracked one, test the module output |
| Induction cooktop | Zone will not recognize a pan, flashing symbol, or a whole side dead | Pan detection coil fault, a power board that lost a phase, or a relay opened by a surge | Check supply at both legs, test the generator board, replace the board or coil the readings indicate |
| Compact washer or dryer (24-inch) | E:17 or E:18 on the washer, dryer taking two cycles | Slow fill from a partly closed valve or clogged screen; drain pump debris; condenser dryer with a blocked heat exchanger | Clear screens and pump, replace a weak fill valve, clean the exchanger and sensor |
Bosch error numbers explained
| Error number | What it points to | Service step |
|---|---|---|
| E15 | Water collected in the base pan has lifted the flood float; in most cases a leak, though heavy foam from the wrong detergent produces the same result | Find and repair the leak source, dry the pan completely, reset and run a test cycle |
| E24 | The dishwasher could not drain; typically a clogged filter, a blocked or kinked hose, or a disposer knockout plug never removed on a new install | Clear filter and hose, confirm the drain path to the disposer or air gap, test pump pressure |
| E25 | Drain pump or its cover is obstructed or the impeller is jammed; small glass shards are a frequent culprit | Lift the pump cover, pick out the debris, change the pump if the motor is seized |
| E09 | Heating fault; usually the flow-through heater is open or its relay has burned, less often the water-level sensor | Meter the heater element, inspect the relay on the control, replace the failed component |
| E22 | Standing water detected; the filter is dirty or the sump has not emptied since the last cycle | Clean filter and sump, check the check valve, verify a full drain on a test run |
Why Olympia water matters to a Bosch
Bosch dishwashers are sensitive to what comes out of the tap. Inside the city, Olympia's groundwater is moderately hard with a little manganese, enough to leave a gray film on the tub and slowly coat the heater. Out past the city line, on wells in glacial till around Steamboat Island, Summit Lake, Delphi and Mud Bay, iron and hardness are heavier, and we see Bosch heaters scaled to failure and rinse-aid dispensers gummed shut. Septic homes need the drain to behave, and a Bosch that fails to pump out can back up into a sink. We ask about your water and your drain when you book, because the answers change what parts we bring.
Power is the other local factor. Bosch controls dislike the November windstorms and the flicker before a full outage; the morning after brings induction cooktops with a dead side and dishwashers showing new codes, and often a reset or a relay is the cure. Every completed repair leaves you with a printed invoice showing the warranty period on the part and the labor. Should a component need ordering, our return appointment adds nothing to your total. Owners of Bosch-equipped condos at the Port or rentals near the college can approve by phone or email and get an emailed invoice, and building or gate codes are erased when the ticket closes. We are independent, and where Bosch's own coverage still reaches your unit, you will hear it from us before any money moves.
Bosch questions
My Bosch dishwasher shows E15 and will not run. What do I do?
E15 means water has collected in the base pan. Pulling the dishwasher out and tipping it to drain the pan sometimes lets it run again, but the leak that put the water there is still present. We find the source, often a sump seal or a splashing spray arm, fix it, and dry the pan so the float resets properly.
E24 keeps coming back even after I clean the filter. Why?
Repeated E24 with a clean filter usually points past the filter: a hose bent double behind the cabinet, a check valve stuck partly closed, a disposer inlet that was never opened, or a drain pump losing strength. We test the pump's flow and inspect the whole path to the sink, not just the filter.
Why are my dishes wet at the end of a Bosch cycle?
Bosch machines dry by condensation, so some moisture on plastics is normal. Puddles on everything, though, usually mean the heater or its relay has failed, sometimes with an E09 code. Rinse aid matters too. We test the heater's resistance and the control output and replace whichever is out of spec.
Do you work on Bosch induction cooktops and gas rangetops?
Yes. Induction faults often trace to a generator board or a coil, and a surge from a storm can open a relay so half the cooktop goes dark. Gas rangetops mostly bring us igniter and spark-module problems. We test both electrical legs first, because a lost leg mimics a failed board.
Is my Bosch dishwasher too old to be worth repairing?
Bosch tubs are stainless and the frames last, so a ten- or twelve-year-old machine is often a good repair. A pump, a heater or a control is a fraction of what a new 800 series costs. If the sump housing itself is cracked we tell you, and the visit fee is the extent of the visit.
Full code sheet
Other brands
How a visit runs
Four stages, none skipped
The price goes on paper before a screw comes out.
- 01
Tell us what it is doing
Ring or use the form; a phone photo of the display or the model sticker saves a step. The shop calls you back to set an arrival window, and once more as the van pulls off Woodland Square Loop.
- 02
Readings first, opinions second
The technician tests the suspect part with instruments, tells you in plain words what gave out, and writes the repair down as a single price. The visit fee is already inside that number.
- 03
Most parts ride in the van
Fill valves, defrost heaters, igniters, drum rollers, drain pumps, relays — the things well water, salt air and winter outages wear out on this shore of the inlet. If the part has to come in by order, the return trip is on us.
- 04
A test run, then the invoice
You see a full cycle run start to finish, the kick panels and floor go back the way we found them, and the warranty term is typed onto the invoice.
Bosch repair in Olympia: read us the code.
Tell us over the phone or book a day online. A technician tests the machine and writes the repair down as one price with the visit fee folded in; your invoice spells out the warranty term.